Seagate ST336706LC SCSI Hard Drive
Item Number: SGT-ST336706LC-RF-OE
Manufacturer's Part Number: ST336706LC |
  |
| |
Seagate Cheetah 36ES 36GB 10K U160 80pin SCA-2 SCSI Hard Drive ST336706LC - Refurbished |
| |
$75.00
Quantity available for shipping today: 1 Need more? |
 |
| |
 |
 |
Capacity: 36GB
Spindle Speed: 10,000RPM
Interface Type: SCSI 80pin SCA-2 (Hot-Swap)
Disk Size: 3.5"x1.0" (Low Profile Hard Drive)
Sustained Throughput (MBps): 52 to 68
Average Seek Time (read/write ms): 2.99
Electrical Interface Speed: SCSI LVD U160 - 160MBps 16-bit
On-Board Cache: 4MB |
| |
|
|
| These drives will fit in any of our SCSI hard drive trays:
|
| |
|
|
|
|
|
|
|
| |
|
|
Cheetah 36ES drives combine giant magnetoresistive (GMR) heads, partial response/maximum likelihood (PRML) read channel electronics, embedded servo technology, and a wide SCSI Ultra160 interface to provide high performance, high capacity data storage for a variety of systems including engineering workstations, network servers, mainframes, and supercomputers.
The Cheetah 36ES family has the following standard features:
• Integrated Ultra160 SCSI controller
• Multimode SCSI drivers and receivers—single-ended (SE) and low voltage differential (LVD)
• 16 bit I/O data bus
• Asynchronous and synchronous data transfer protocol
• Firmware downloadable via SCSI interface
• Selectable even byte sector sizes from 512 to 4,096 bytes/sector
• Programmable sector reallocation scheme
• Flawed sector reallocation at format time
• Programmable auto write and read reallocation
• Reallocation of defects on command (post format)
• Enhanced ECC maximum burst correction length of 240 bits with a guaranteed burst correction length of
233 bits
• Sealed head and disc assembly
• No preventative maintenance or adjustment required
• Dedicated head landing zone
• Embedded servo design
• Self diagnostics performed when power is applied to the drive
• 1:1 Interleave
• Zoned bit recording (ZBR)
• Vertical, horizontal, or top down mounting
• Dynamic spindle brake
• 4,096 kbyte data buffer
• Hot plug compatibility (Section 9.6.4.2 lists proper host connector needed) for LC model drives
• Drive Self Test (DST)
Compatibility
|
| |
|
|
ST-336706LW
UNFORMATTED CAPACITY (GB) ________________
FORMATTED CAPACITY (GB) __________________36.7
AVERAGE SECTORS PER TRACK ________________681 rounded down
ACTUATOR TYPE ____________________________ROTARY VOICE COIL
TRACKS ___________________________________105,208
CYLINDERS ________________________________26,302 user
HEADS ______PHYSICAL______________________4
DISCS (3.5 in) ___________________________2
MEDIA TYPE _______________________________THIN FILM/GMR
RECORDING METHOD _________________________PRML 16/17 EPR4
INTERNAL TRANSFER RATE (mbits/sec)________530 to 674
INTERNAL FORMATTED TRANSFER RATE (MB/sec)_52 to 68
EXTERNAL TRANSFER RATE (mbyte/sec) _______40 Sync
Low Voltage Differential(LVD) _______80/160 Sync
SPINDLE SPEED (RPM) ______________________10,028
AVERAGE LATENCY (mSEC) ___________________2.99
BUFFER ___________________________________4MB
Read Look-Ahead, Adaptive, Multi-Segmented Cache
INTERFACE ________________________________Ultra SCSI Wide
Low Voltage Differential __________Ultra3-SCSI Wide
ASA II, SCAM level 2 (1 default)
BYTES PER TRACK __________________________348,900 avg
SECTORS PER DRIVE ________________________71,687,369
TPI (TRACKS PER INCH) ____________________38,000
BPI (PEAK KBITS PER INCH) ________________460
AVERAGE ACCESS (ms read/write)____________5.2/6.2
Drive level without controller overhead
SINGLE TRACK SEEK (ms read/write) ________0.5/0.9
MAX FULL SEEK (ms read/write) ____________10.0/11.0
MTBF (power-on hours) ____________________1,200,000
SHOCK (G's, 11/2/.5 ms):
operating (Read/Write) __________15
abnormal ________________________40
nonoperating ____________________/250/150
ACOUSTICS (Bels typical) ________Idle ____3.2
Max ____
POWER DISSIPATION (watts/BTUs) Active ____/
Idle ______12.4/42.31
POWER REQUIREMENTS: +12V START-UP (amps) _2.25
+12V TYPICAL (amps) __0.70 idle
+5V START-UP (amps) __1.00
+5V TYPICAL (amps) ___0.80 idle
IDLE (watts) _________
Physical:
Height (inches/mm): 1.00/25.4
Width (inches/mm): 4.00/101.6
Depth (inches/mm): 5.75/146.05
Weight (lbs/kg): 1.76/0.798
Click here to view the manufacturers item description/brochure |
| |
|
|
| |
 |
Specifications subject to change at any time. DiscounTechnology is not responsible for errors or omissions.
Actual products may vary from images displayed. |
| |
|
|
|
 "ST336706LC SCSI Hard Drive Photo")
 "ST336706LC SCSI Hard Drive Photo")
 "ST336706LC SCSI Hard Drive Photo")
 "ST336706LC SCSI Hard Drive Photo")
