Seagate ST336704LC SCSI Hard Drive

Capacity: 36GB
Spindle Speed: 10,000RPM
Interface Type: SCSI 80pin SCA-2 (Hot-Swap)
Disk Size: 3.5"x1.0" (Low Profile Hard Drive)
Sustained Throughput (MBps): 26.7 to 40.2
Average Seek Time (read/write ms): 5.4 / 6.2
Electrical Interface Speed: SCSI LVD U160 - 160MBps 16-bit
On-Board Cache: 16MB

The Cheetah 36LP family has the following standard features:

• Integrated Ultra160 SCSI controller
• Multimode SCSI drivers and receivers—single-ended (SE) and low voltage differential (LVD)
• 16 bit I/O data bus
• Asynchronous and synchronous data transfer protocol (supports Ultra160 transfer rate)
• Firmware downloadable via SCSI interface
• Selectable even byte sector sizes from 512 to 2,064 bytes/sector
• Programmable sector reallocation scheme
• Flawed sector reallocation at format time
• Programmable auto write and read reallocation
• Reallocation of defects on command (post format)
• ECC maximum burst correction length of 240 bits with a guaranteed burst correction length of 233 bits.
• Sealed head and disc assembly
• No preventative maintenance or adjustment required
• Dedicated head landing zone
• Embedded servo design
• Self diagnostics performed when power is applied to the drive
• Zoned bit recording (ZBR)
• Vertical, horizontal, or top down mounting
• Dynamic spindle brake
• 4,096 kbyte data buffer (16,384 kbytes on LWV and LCV models)
• Hot plug compatibility (Section 9.6.4.2 lists proper host connector needed) for LC and LCV model drives
• Drive Self Test (DST)
• Supports SCSI bus fairness

Media characteristics

The media used on the drive has a diameter of approximately 3.3 inches (84 mm). The aluminum substrate is
coated with a thin film magnetic material, overcoated with a proprietary protective layer for improved durability
and environmental protection.

Performance

• Supports industry standard Ultra3 SCSI interface
• Programmable multi-segmentable cache buffer (see Section 4.5)
• 10,033 RPM spindle. Average latency = 2.99 ms
• Command queuing of up to 64 commands
• Background processing of queue
• Supports start and stop commands (spindle stops spinning)

Reliability

• 1,200,000 hour MTBF
• LSI circuitry
• Balanced low mass rotary voice coil actuator
• Incorporates industry-standard Self-Monitoring, Analysis and Reporting Technology (S.M.A.R.T.)

Compatibility

                         SEAGATE TECHNOLOGY, INC.
                              1-800-SEAGATE
                          http://www.seagate.com
                            (C)opyright 1999


ST-336704LW Ultra160 SCSI Wide (Cheetah 36LP, LVD)

  ÉÍÍÍÍÍÍÍÍÍÍÍ»
  º REAR VIEW º  (ST-336704LW/LWV only)
  ÈÍÍÍÍÍÍÍÍÍÍͼ
        (TOP)                  J5 Auxiliary
          ___________________  ÚÄÄ  Ä1¿/ÍÍÍÍÍÍÍÍÍ\
        Í( ×××××××××××××××××1)ͳ::::::³³ 0 0 0 0 ÆÍ
          \ÄÄÄÄÄÄÄÄÄÄÄijÄÄÄÄ/  À  ÄÄ 2ÙÀÄ5ÄGÄGÄ12Ù
       68 pin I/O CableÙ        ³³³³³³
       Connection Male          ³³³³³³   SCSI ID = 0 (none)
                                ³³³³³ÀÄÄ SCSI ID = 1
                   pin-11 +5v ÄÄÙ³³³ÀÄÄÄ SCSI ID = 2
                   pin-10 GND ÄÄÄÙ³ÀÄÄÄÄ SCSI ID = 4
                                  ÃÄÄÄÄÄ SCSI ID = 8
      pins 9 & 12 no connection   ÀÄÄÄÄÄÄ or pin-8 Activity LED*

* These pins are driven low for 250ms after PWR ON and RESET
  to allow jumper selectable SCSI ID as shown above.


  ÉÍÍÍÍÍÍÍÍÍÍÍ»
  º REAR VIEW º  (ST-336704LC/LCV only)
  ÈÍÍÍÍÍÍÍÍÍÍͼ
                     80 pin I/O and DC Power Wall/bracket Connection
                     ³  Female
    J1          /ÄÄÄijÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ\      TOP (HDA)
     ÍÍÍÍÍÍÍÍÍÍ/ ×××××××××××××××××××× \ÍÍÍÍÍÍÍÍÍÍ
              (\Ä1ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ40/)    BOTTOM

     Notes on 80 pin I/O connector:
       pins  1 -  4 = +12v        41 - 44 = 12v GND
            34 - 36 = +5v         74 - 76 = 5v GND
                 37 = SYNC             77 = LEDC
                 38 = MTRON            78 = DLYDST
                 39 = SCSIA0           79 = SCSIA1
                 40 = SCSIA2           80 = SCSIA3

  Mating connector: AMP US p/n: 2-557103-1 straight-in, Male 80-pin
                                   2-557101-1 right angle to PCB

  ÉÍÍÍÍÍÍÍÍÍÍÍ»
  º SIDE VIEW º  (ST-336704LW/LC)
  ÈÍÍÍÍÍÍÍÍÍÍͼ

             FRONT    TOP (HDA)    J2  87654321              Õ͸
              OF ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍPÍWÍAÍÍÍÍÍ͵J1
             DRIVE    BOTTOM           ::::::::              Ô;
                                       ³³³³³³³³
 Force Single-ended (LVD models only) ÄÙ³³³³³³À Term Power (LW only)¿
           Start Delay (12 secs * ID) ÄÄÙ³³³³ÀÄ Reserved            ³
                          Motor Start ÄÄÄÙ³³ÀÄÄ Reserved            ³
                        Write Protect ÄÄÄÄÙÀÄÄÄ Parity Disable      ³
                                                                    ³
                                                                    ³
                    ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿              ³
                    ³ Termination Power-source Table ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ
                    ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄ¿
                    ³               ....ÍÍÍÍÍPWA edgeÍÍÍÍÍ ³
                    ³                            2 1       ³
                    ³ A Drive Supplies Bus        ÖÄ·      ³
                    ³                            øºøº      ³
                    ³  (not used on LC model)    øÓø½      ³
                    ³                             A        ³
                    ÀÄÄÄÄÄÄÄÄÄDefault no jumper ÄÄÄÄÄÄÄÄÄÄÄÙ

     Note: LW and LC drives do not have internal terminators or
           any other way of adding internal terminators to the
           drive; use external active termination if required.
           Use active (ANSI SCSI-2 Alternative 2) terminators
           when terminating the bus.  Use active negation
           terminators when terminating a SCSI Ultra2 bus
           operating in Low Voltage Differential (LVD) mode.

  ÉÍÍÍÍÍÍÍÍÍÍÍÍ»
  º FRONT VIEW º  (ST-336704LW/LC)
  ÈÍÍÍÍÍÍÍÍÍÍÍͼ
                                  ÚÄÄ´Reserved. Shipped with cover installed.
                                  ³  ÀDo not remove. Do not install jumpers
                      TOP (HDA)  ÕØÍÍ͸     1
     ÍÍPÍWÍAÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ͵::::³::::::ÆÍÍ
                 *    BOTTOM     ÔÍÍÍ;123456
                 ³               J6    ³³³³³³
            LED ÄÙ                     ³³³³³³
                            Remote LED Ù³³³³À ID 1
                           (pin-11 +5v) ³³³ÀÄ ID 2
                              Reserved ÄÙ³ÀÄÄ ID 4
                           (pin-10 GND)  ÀÄÄÄ ID 8



                            ST-336704LW



       UNFORMATTED CAPACITY (GB) ________________43.7
       FORMATTED CAPACITY (GB) __________________36.7
       AVERAGE SECTORS PER TRACK ________________423 rounded down
       ACTUATOR TYPE ____________________________ROTARY VOICE COIL
       TRACKS ___________________________________169,200
       CYLINDERS ________________________________14,100 user
       HEADS ______PHYSICAL______________________12
       DISCS (3.0 in) ___________________________6
       MEDIA TYPE _______________________________THIN FILM/GMR
       RECORDING METHOD _________________________PRML 16/17 EPR4
       INTERNAL TRANSFER RATE (mbits/sec)________280 to 427
       INTERNAL FORMATTED TRANSFER RATE (MB/sec)_26.7 to 40.2
       EXTERNAL TRANSFER RATE (mbyte/sec) _______40 Sync
            Low Voltage Differential(LVD) _______80/160 Sync
       SPINDLE SPEED (RPM) ______________________10,033
       AVERAGE LATENCY (mSEC) ___________________2.99
       BUFFER (/optional LWV and LCV) ___________4MB/16MB
         Read Look-Ahead, Adaptive,
         Multi-Segmented Cache
       INTERFACE ________________________________Ultra-SCSI Wide
              Low Voltage Differential __________Ultra3-SCSI Wide
              ASA II, SCAM level 2 (1 default)
       BYTES PER TRACK __________________________215,248
       SECTORS PER DRIVE ________________________71,687,369
       TPI (TRACKS PER INCH) ____________________18,145
       BPI (PEAK KBITS PER INCH) ________________334
       AVERAGE ACCESS (ms read/write)____________5.4/6.2
         Drive level without controller overhead
       SINGLE TRACK SEEK (ms read/write) ________0.8/1.1
       MAX FULL SEEK (ms read/write) ____________11.2/11.9
       MTBF (power-on hours) ____________________1,200,000
       SHOCK (G's, 11/2/.5 ms):
                operating (Read/Write) __________10
                abnormal ________________________40
                nonoperating ____________________75/200/100
       ACOUSTICS (Bels typical, sound power) ____3.9
       POWER DISSIPATION (watts/BTUs) Active ____/
                                      Idle ______10.91/37.2
       POWER REQUIREMENTS: +12V START-UP (amps) _2.2
                           +12V TYPICAL (amps) __0.58 idle
                           +5V START-UP (amps) __0.86
                           +5V TYPICAL (amps) ___0.79 idle
                           IDLE (watts) _________
       LANDING ZONE (cyl) _______________________AUTO PARK
       IBM AT DRIVE TYPE ________________________0 or NONE

       Physical:
                        Height (inches/mm):      1.0/25.4
                        Width  (inches/mm):     4.00/101.6
                        Depth  (inches/mm):     5.75/146
                        Weight    (lbs/kg):      1.3/0.589

Already low-level formatted at the factory with x spare sectors at
the end of each x cylinder region.  

ZBR = Zone Bit Recording = Variable sectors per track


Seagate reserves the right to change, without notice, product 
offerings or specifications. (12/21/99)