|
|
Seagate ST3146707LC SCSI Hard Disk
Item Number: SGT-ST3146707LC-RF-OE
Manufacturer's Part Number: ST3146707LC |
  |
| |
| Seagate Cheetah 10K.7 146GB 10K U320 80pin SCA-2 SCSI Hard Drive - Refurbished
|
| |
 |
 |
Capacity: 146GB
Spindle Speed: 10,000RPM
Interface Type: SCSI 80pin SCA-2 (Hot-Swap)
Disk Size: 3.5"x1.0" (Low Profile Hard Drive)
Sustained Throughput (MBps): 59.5
Average Seek Time (read/write ms): 4.7 / 5.3
Electrical Interface Speed: SCSI LVD U320 - 320MBps 16-bit
On-Board Cache: 8MB |
| |
|
|
Here are some hot swap drive trays that are compatible with this drive as well as some drives of similar capacity. |
|
| |
|
|
ST-3146707LW Ultra320 SCSI Wide (Cheetah 10K.7, LVD)
ÉÍÍÍÍÍÍÍÍÍÍÍ»
º REAR VIEW º (ST-3146707LW only)
ÈÍÍÍÍÍÍÍÍÍÍͼ
(TOP) J5 Auxiliary
___________________ ÚÄÄ Ä1¿/ÍÍÍÍÍÍÍÍÍ\
Í( ×××××××××××××××××1)ͳ::::::³³ 0 0 0 0 ÆÍ
\ÄÄÄÄÄÄÄÄÄÄÄijÄÄÄÄ/ À ÄÄ 2ÙÀÄ5ÄGÄGÄ12Ù
68 pin I/O CableÙ ³³³³³³
Connection Male ³³³³³³ SCSI ID = 0 (none)
³³³³³ÀÄÄ SCSI ID = 1
pin-11 +5v ÄÄÙ³³³ÀÄÄÄ SCSI ID = 2
pin-10 GND ÄÄÄÙ³ÀÄÄÄÄ SCSI ID = 4
ÃÄÄÄÄÄ SCSI ID = 8
pins 9 & 12 no connection ÀÄÄÄÄÄÄ or pin-8 Activity LED*
* These pins are driven low for 250ms after PWR ON and RESET
to allow jumper selectable SCSI ID as shown above.
ÉÍÍÍÍÍÍÍÍÍÍÍ»
º REAR VIEW º (ST-3146707LC only)
ÈÍÍÍÍÍÍÍÍÍÍͼ
80 pin I/O and DC Power Wall/bracket Connection
³ Female
J1 /ÄÄÄijÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ\ TOP (HDA)
ÍÍÍÍÍÍÍÍÍÍ/ ×××××××××××××××××××× \ÍÍÍÍÍÍÍÍÍÍ
(\Ä1ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ40/) BOTTOM
Notes on 80 pin I/O connector:
pins 1 - 4 = +12v 41 - 44 = 12v GND
34 - 36 = +5v 74 - 76 = 5v GND
37 = SYNC 77 = LEDC
38 = MTRON 78 = DLYDST
39 = SCSIA0 79 = SCSIA1
40 = SCSIA2 80 = SCSIA3
Mating connector: AMP US p/n: 2-557103-1 straight-in, Male 80-pin
2-557101-1 right angle to PCB
ÉÍÍÍÍÍÍÍÍÍÍÍ»
º SIDE VIEW º (ST-3146707LW only)
ÈÍÍÍÍÍÍÍÍÍÍͼ
FRONT TOP (HDA) J2 87654321 Õ͸
OF ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍPÍWÍAÍÍÍÍÍ͵J1
DRIVE BOTTOM :::::::: Ô;
³³³³³³³³
Force SingAle-ended (LVD models only) ÄÙ³³³³³³À Term Power (LW only)¿
Start Delay (12 secs * ID) ÄÄÙ³³³³ÀÄ Reserved ³
Motor Start ÄÄÄÙ³³ÀÄÄ Reserved ³
Write Protect ÄÄÄÄÙÀÄÄÄ Parity Disable ³
³
³
ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ³
³ Termination Power-source Table ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ
ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄ¿
³ ....ÍÍÍÍÍPWA edgeÍÍÍÍÍ ³
³ 2 1 ³
³ A Drive Supplies Bus ÖÄ· ³
³ øºøº ³
³ (not used on LC model) øÓø½ ³
³ A ³
ÀÄÄÄÄÄÄÄÄÄDefault no jumper ÄÄÄÄÄÄÄÄÄÄÄÙ
Note: LW and LC drives do not have internal terminators or
any other way of adding internal terminators to the
drive; use external active termination if required.
Use active (ANSI SCSI-2 Alternative 2) terminators
when terminating the bus. Use active negation
terminators when terminating a SCSI Ultra2 bus
operating in Low Voltage Differential (LVD) mode.
ÉÍÍÍÍÍÍÍÍÍÍÍÍ»
º FRONT VIEW º (ST-3146707LW/LC)
ÈÍÍÍÍÍÍÍÍÍÍÍͼ
ÚÄÄ´Reserved. Shipped with cover installed.
³ ÀDo not remove. Do not install jumpers
TOP (HDA) ÕØÍÍ͸ 1
ÍÍPÍWÍAÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ͵::::³::::::ÆÍÍ
* BOTTOM ÔÍÍÍ;123456
³ J6 ³³³³³³
LED ÄÙ ³³³³³³
Remote LED Ù³³³³À ID 1
(pin-11 +A5v) ³³³ÀÄ ID 2
Reserved ÄÙ³ÀÄÄ ID 4
(pin-10 GND) ÀÄÄÄ ID 8
ST-3146707LW
Cheetah 10K.7
UNFORMATTED CAPACITY (GB) ________________
FORMATTED CAPACITY (GB) __________________146.8
AVERAGE SECTORS PER TRACK ________________789 rounded down
ACTUATOR TYPE ____________________________ROTARY VOICE COIL
TRACKS ___________________________________363,096
CYLINDERS ________________________________90,774 user
HEADS ______PHYSICAL______________________4
DISCS (2.5 in) ___________________________2
MEDIA TYPE _______________________________THIN FILM/GMR
RECORDING METHOD _________________________PRML
INTERNAL TRANSFER RATE (mbits/sec)________470 to 944
INTERNAL FORMATTED TRANSFER RATE (MB/sec)_59 to 118
EXTERNAL TRANSFER RATE (mbyte/sec) _______40 Sync
Low Voltage Differential(LVD) _______80/320 Sync
SPINDLE SPEED (RPM) ______________________10,008
AVERAGE LATENCY (mSEC) ___________________3.00
BUFFER ___________________________________8MB
Read Look-Ahead, Adaptive,
Multi-Segmented Cache
INTERFACE ________________________________Ultra-SCSI Wide
Low Voltage Differential __________Ultra3-SCSI Wide
ASA II, SCAM level 2 (1 default)
BYTES PER TRACK __________________________556K avg
SECTORS PER DRIVE ________________________286,749,488
TPI (TRACKS PER INCH) ____________________105,000
BPI (PEAK KBITS PER INCH) ________________658
AVERAGE ACCESS (ms read/write)____________4.7/5.3
Drive level without controller overhead
SINGLE TRACK SEEK (ms read/write) ________0.2/0.5
MAX FULL SEEK (ms read/write) ____________9.5/10.3
ANNUALIZED FAILURE RATE (AFR) ____________0.62%
SHOCK (G's, 11/2/.5 ms):
operating (Read/Write) ___A_______15/60/
abnormal ________________________40//
nonoperating ____________________75/225/120
ACOUSTICS (Bels typical, sound power) ____3.3
POWER DISSIPATION (watts/BTUs) Active ____/
Idle ______7.78/26.41
POWER REQUIREMENTS: +12V START-UP (amps) _1.89
+12V TYPICAL (amps) __0.42 idle
+5V START-UP (amps) __0.76
+5V TYPICAL (amps) ___0.54 idle
IDLE (watts) _________
Physical:
Height (inches/mm): 1.0/25.4
Width (inches/mm): 4.00/101.6
Depth (inches/mm): 5.75/146
Weight (lbs/kg): 1.6/0.726
ZBR = Zone Bit Recording = Variable sectors per track
Seagate reserves the right to change, without notice, product
offerings or specifications. (04/14/2005)
Click here to view the manufacturers item description/brochure |
| |
|
|
|
|
 "ST3146707LC SCSI Hard Drive Photo"){kind=small}
 "ST3146707LC SCSI Hard Drive Photo"){kind=small}
 "ST3146707LC SCSI Hard Drive Photo"){kind=small}
 "ST3146707LC SCSI Hard Drive Photo"){kind=small}
